South Tyrol, Italy · from St. Leonhard in Passeier

Jaufenpass

The Jaufenpass climb from St. Leonhard in Passeier runs about 19 km and gains roughly 1,400 m, at an average gradient near 7%. The road reaches the pass at about 2,094 m, on the border between the Passeier valley and the Wipptal, and it is one of the four passes of the Ötztaler Radmarathon.

Length
20.5 km
Elevation gain
1,441 m
Avg gradient
7%
Steepest section
16.8%

Summit elevation: 2094 m

Route overview

Jaufenpass · from St. Leonhard in Passeier

StartSummit

Schematic road geometry from OpenStreetMap routing; use it to see the shape of the climb, not for navigation.

Gradient profile

The climb coloured by gradient, with the hairpins and landmarks on the way up.

0 km20.5 km
  • Under 3%
  • 3–6%
  • 6–9%
  • 9–12%
  • Over 12%

How fast would you climb Jaufenpass?

Enter your power and weight. A physics engine calculates your estimated time against the gradient profile.

Predict your
performance.

See how power and weight affect your time on a real climb.

250 W
75 kg
Jaufenpass (Simulated)
Est. Time
...
Set your FTP & weight, then predict
Recovery Threshold VO2 Max

*Demo simulation uses standard road bike physics (CdA 0.32, Crr 0.004).

Plan built from this climb

The climbing guide lays out a structured block for long climbs. Save it as a week-by-week plan with the full schedule. The plan adapts when you miss sessions.

Jaufenpass: 6-Week Climbing Build

6 weeks · 19 sessions · built from this climb

Week 1 · open · Start with controlled endurance, tempo, and sweet spot work at targets calculated from your FTP.

  • Z2 Endurance 60min66 min
  • Tempo 45min56 min
  • Sweet Spot 60minKey session68 min

Weeks 2–6

Save the plan to open the full schedule.

Your time after the plan

Today
1:31:15
for a rider with 250 W FTP, 75 kg
After 6 weeks
1:27:13
if FTP rises 5% to 263 W

Estimates from the same physics model, for a 250 W FTP and 75 kg rider.

Events that include Jaufenpass

These cycling events list Jaufenpass among their key climbs. Each event page has a preparation roadmap and key training sessions.

All cycling events

Training for long climbs

The climbing training guide covers the phases, a sample week and key workouts for sustained efforts on mountain passes.

Read the climbing training guide

Built from this goal

Renting a bike? Check the size

Get the frame size and setup for your height and inseam before you ride Jaufenpass.

Open Bike Fit

Plan the loop

Plan a ride that includes Jaufenpass in the Route Planner.

Open Route Planner

Film the climb

Turn your ride up Jaufenpass into a 3D film.

Open 3D Flyover

FAQ

How long is the Jaufenpass climb?

From St. Leonhard in Passeier, the climb is about 20.5 km with roughly 1,441 m of elevation gain at 7% average gradient (based on the simplified profile used by this simulator; published figures vary slightly by source).

How long does it take to cycle up Jaufenpass?

It depends almost entirely on your power-to-weight ratio. Use the simulator on this page: enter your FTP and weight, and a physics model (air resistance, rolling resistance, gravity) estimates your time on the gradient profile.

How accurate is the time simulation?

The simulator uses a simplified segment profile and standard road bike assumptions (CdA 0.32, Crr 0.004, 8 kg bike). It does not model wind, drafting, altitude, surface or pacing errors, so treat the result as a realistic estimate, not a guarantee.

How should I train for Jaufenpass?

Sustained climbs reward steady threshold and sweet spot work plus a power-to-weight improvement over weeks, not days. TrainCraft builds structured cycling training plans and adapts them when you miss sessions, using fatigue science.

The profile is simplified into 74 segments for simulation; real gradients vary metre by metre. Stats shown are derived from this simulated profile and closely match commonly published figures. Time estimates assume standard road bike physics and no wind.